MMC Trunk Cables
New Zealand engineering teams can use the documented values below to compare the product with the intended channel and as-built requirements. Made-to-order MMC trunk cables are pre-terminated OS2 backbone assemblies for high-capacity routes between panels, racks and distribution areas. MMC-16 and MMC-24 families support separate sub-unit organizations and scalable fiber counts, with design data confirmed against every project layout.
MMC-16 and MMC-24 organize capacity differently
The MMC-16 product line covers 16–384 fibers; at the same time, MMC-24 covers 24–576 fibers. Fiber count affects cable diameter, sub-unit arrangement and handling criteria. The alternative must be consistent with the connected panels and hardware patch leads; a separate sub-unit organization cannot be corrected by an adapter alone.
Project specifications go beyond length
A trunk enquiry ought to define meter or foot length, complete fiber count, connector gender, trunk or extender polarity, breakout dimensions and tags. Pulling protection and deployment loads should be considered for tray or conduit routes. Product line-level tensile and diameter ranges are not equivalent to a substitute for the final design layout.
Factory termination changes the installation process
Instead of polishing and allocation several fibers on site, installation teams pull one documented item and connect it to the planned panels. Allow enough space for static bend radius and rear cable management. Test records and sub-unit tags should be retained with the rack documentation for future fault isolation and expansion.
Ordering and Factory Support
Factory design for this section can cover fiber count, sub-unit allocation, length, connector gender, polarity, breakout geometry and deployment tags. Provide quantities and the intended deployment or test plan with the order. Standard and made-to-order products should be checked against the specification list on arrival, with tags and design records retained for service work. New Zealand project orders can include documentation and labeling requirements alongside the technical configuration.
