10/100BASE-T SFP50G SFP56 Active DAC
The 50G SFP56 Active DAC series provides 50Gbps direct-attached connectivity using the interfaces shown in the specification table. The assembly combines active copper interfaces with signal conditioning in the connector ends in one tested product. This page covers the family rather than a single length, with standard options of 1m (3ft), 2m (7ft), 3m (10ft), 5m (16ft), 7m (23ft) and custom project lengths available for review.
Series Part Number: SFP-50G-ACManufacturer: HT
Product Highlights
- the interfaces shown in the specification table direct-attached interface arrangement
- Supports 50Gbps links
- Standard lengths: 1m (3ft), 2m (7ft), 3m (10ft), 5m (16ft), 7m (23ft)
- Factory-tested complete cable assemblies for enterprise, operator and data-center installations
Available Lengths
Available standard configurations include 1m (3ft), 2m (7ft), 3m (10ft), 5m (16ft), 7m (23ft). Select a length that follows the managed route without pulling on either connector or leaving excessive slack around airflow paths. Custom lengths can be manufactured for projects when the standard range does not match the installation.
Specifications
| Series Part Number | SFP-50G-AC |
|---|---|
| Manufacturer | HT |
| Form Factor | SFP56 |
| Max Data Rate | 50Gbps |
| Cable Type | Active Twinax |
| Max Cable Distance | Up to 7m |
| Available Length Options | 1m (3ft), 2m (7ft), 3m (10ft), 5m (16ft), 7m (23ft) |
| Wire AWG | 30AWG |
| Power Consumption | ≤0.5W |
| Jacket Material | PVC |
| Storage Temperature | -40 to 85°C (-40 to 185°F) |
| Operating Temperature | 0 to 70°C (32 to 158°F) |
| Modulation Technology | PAM4 |
| Bit Rate | 53.125 Gbps |
| Protocol | SFP56 MSA |
Applications and Cable Routing
This 50G ACC series can be used for suitable switch-to-switch, switch-to-server and rack interconnection requirements. Measure the actual pathway through horizontal and vertical managers before choosing a length. Keep connector boots clear of sharp edges, observe the stated bend limit and leave enough access to release each latch during maintenance.
Compatibility and Factory Testing
Compatibility depends on the host interface, operating mode and the identification required by the equipment. For brand-coded versions, provide the equipment model and OEM reference so the intended configuration can be reviewed before production. Each complete assembly is inspected at both ends and checked for link operation; optical versions also require clean, protected interfaces throughout installation.
Ordering Information
Quote the SFP-50G-AC series together with the required length, host brand, OEM reference where applicable and quantity. Mixed-length projects should use a separate order line for each configuration. Project labels and packaging can identify rack locations or endpoint assignments to make receiving and later maintenance easier.
Related Product Configuration
Additional factory information for this cable family is available on the 50G SFP56 Active DAC configuration page. You can also compare adjacent assemblies in the 50G ACC cable collection.
Quality Assurance and Shipping
Connector condition, assembly identification and functional link behavior are checked before protective packing. Standard configurations are prepared for dispatch as quickly as stock allows, while larger or customized orders receive a confirmed production schedule. Local and international delivery options are available.
Frequently Asked Questions
Does this page represent only one cable length?
No. It describes the product series and lists the standard length options. Confirm the exact length and corresponding order reference when requesting a quotation.
Are separate transceivers required?
No. The cable and its attached interfaces form one complete direct-attached assembly and are tested together.
Can a custom length or brand-compatible version be supplied?
Yes, subject to configuration review. Provide the required length, equipment model and OEM part number so compatibility and production details can be confirmed.
