MMC to MMC 1-Port Fiber OpticMMC to MMC 1-Port Fiber Optic Adapter/Coupler without Flange
New Zealand engineering teams can use the documented values below to compare the product with the intended channel and as-built requirements. This one-port MMC-to-MMC adapter provides a single mating mounting point in a compact green plastic body. The reduced-flange design measures 12.9 x 5.8 x 29.6mm and is appropriate for compatible MMC panel cut-outs. It offers a simple building block for project-specific faceplates, enclosures and low-count MMC patching positions.
Product Highlights
- Connector Type: MMC-MMC
- Body Style: 1-Port
- Color: Green
- Mounting Type: Reduced Flanged
- Body Material: Plastic
- Dimensions (HxWxD): 12.9x5.8x29.6mm
Specifications
| Part Number | 24925 |
|---|---|
| Manufacturer | HT |
| Connector Type | MMC-MMC |
| Body Style | 1-Port |
| Color | Green |
| Mounting Type | Reduced Flanged |
| Body Material | Plastic |
| Dimensions (HxWxD) | 12.9x5.8x29.6mm |
A single position for custom panel layouts
The one-port body is helpful where only one MMC joint is intended or where positions must be spaced individually across a faceplate. It avoids committing panel space to a multi-port block. evaluate the cut-out against the 5.8mm body width and 12.9mm height, and cross-check that the reduced-flange mounting style matches the enclosure design before fabrication.
Alignment, gender and polish are separate checks
The relevant adapter aligns two MMC connectors but does not on its own change connector gender, fiber count or polish. Ensure that the two cable or device interfaces are intended to mate and that their guide-pin arrangement is compatible. Use matching polish types and keep the mounting point dust-capped when empty; an adapter cannot compensate for a contaminated or damaged ferrule.
Installation and maintenance access
Leave adequate space in front of the relevant adapter for the push-pull boot and adequate space behind it for cable bend radius. A single connector in a dense panel may still be difficult to remove if adjacent cabling blocks the boot. Review and clean the two MMC end faces before final connection, and avoid using the relevant adapter body as a cable support point.
Ordering and Factory Support
Reference part number 24925 for the one-port reduced-flange adapter. Submit quantity and, if it will be fitted in a project-specific panel, provide the cut-out layout or a sample panel requirement so mounting compatibility can be reviewed. New Zealand project orders can include documentation and labeling requirements alongside the technical configuration.
